no 4wd

19674x4 · Post by **19674x4** » Sat Jan 21, 2006 8:37 pm

ok, i put new wheel bearing in my front end and, of course to to this you have to take the whole hub assembly off, whell, i numbered them as i took it apart and put it back together exactly the same. But when i turned the hubs in and spun the front drive shaft, my wheels did not turn, what did i do wrong?

fordman · Post by **fordman** » Sat Jan 21, 2006 8:44 pm

were both wheels off the ground or just one? do you have positrac in that axle?

19674x4 · Post by **19674x4** » Sat Jan 21, 2006 8:53 pm

both wheels were off the ground and it is a stock Dana 44 from a 67 highboy f-250

fordman · Post by **fordman** » Sat Jan 21, 2006 9:05 pm

ok could you have put something in backwards.

heep70 · Post by **heep70** » Sun Jan 22, 2006 2:04 pm

Its an open frontend, the driveline will not spin. Try bracing one wheel and spin the other.

The FORDification.com Forums

no 4wd

no 4wd

re: no 4wd