Now I have to figure out what I'm going to fill that hole with. First thought was JB Weld, as I doubt that would shrink and ruin any finish I put on the column... Anybody out there in ford land got any ideas or experience with this?
Any ideas?
Moderator: FORDification
-
fordamericana
- Preferred User
- Posts: 289
- Joined: Fri May 28, 2010 8:36 pm
- Location: The Valley, California...
Any ideas?
I have shortened my column, and removed the boss for the column shifter as I have made my truck a floor shift automatic using a mustang t-handle shifter.
Now I have to figure out what I'm going to fill that hole with. First thought was JB Weld, as I doubt that would shrink and ruin any finish I put on the column... Anybody out there in ford land got any ideas or experience with this?
Now I have to figure out what I'm going to fill that hole with. First thought was JB Weld, as I doubt that would shrink and ruin any finish I put on the column... Anybody out there in ford land got any ideas or experience with this?
I likes My FE I does...
-
fordman
- 100% FORDified!
- Posts: 22329
- Joined: Sun Aug 28, 2005 8:17 pm
- Location: Kansas, Ottawa
- Contact:
Re: Any ideas?
a plastic plug. that is pot metal. welded won't work. maybe brazing.
-
BobbyFord
- 100% FORDified!
- Posts: 5383
- Joined: Sun Feb 04, 2007 9:52 am
- Location: Chatsworth, California
Re: Any ideas?
A correct size freeze plug, then the JB Weld or equivelent epoxy, sand, primer, paint.
-
fordamericana
- Preferred User
- Posts: 289
- Joined: Fri May 28, 2010 8:36 pm
- Location: The Valley, California...
Re: Any ideas?
I like the sound of that idea, I'll try it.BobbyFord wrote:A correct size freeze plug, then the JB Weld or equivelent epoxy, sand, primer, paint.
I likes My FE I does...