djm I beams for 3/4 ton ?

[wwjd63]

I looked everywere for the djm dream beams,but can't find them anywere .
They only make these for the F100/F150 the ones made for the F250 are late model fords "99" & up.
If i can't find them is there another way to lower a (72 3/4 ton F250)

Thanks guys

[wickedinhere]

I just saw where someone used the ones for a f-100 on a f-250.

[wickedinhere]

Check out the last post in this thread.http://www.fordification.com/forum/view ... =5&t=39869

[wwjd63]

Check out the last post in this thread.http://www.fordification.com/forum/view ... =5&t=39869

Thanks "wickedinhere" But just one thing, i wonder if there would be a problem with king-pin size
I only need to lower 2"-3"in front.

[wickedinhere]

I just looked at lmc and they call for the same king pins for f-100 and f-250 years 67-72 so you sould be good.
I recommend changing your king pins while your in there.

[69NVF100]

wwjd63, I got my beams at summit they had them in stock.

[wwjd63]

I just looked at lmc and they call for the same king pins for f-100 and f-250 years 67-72 so you sould be good.
I recommend changing your king pins while your in there.

Thanks for looking "wickedinhere" i guess i'll need to get them for an F100 & change my king pins while i'll have it apart, I think i saw some at C.P.P. (classic performance products).

[wwjd63]

wwjd63, I got my beams at summit they had them in stock.

Hi "69nvF100" I Looked at summit for these,but i was looking for a (72 F250) and they didn't have them.
they only had them for the( F100) and i did not know that those would fit my F250 3/4 ton thanks to the guys on this sight i learned a lot about these cool trucks
It's good to see a local on here,I'm getting ready for Hot August Nights.

Thanks again guys.

[69NVF100]

Same here, I hope to be ready for hot august nights but will see. I still need to finish the top end of my motor and do the brakes and steering stuff. Lots to do in a short amount of time.