Which 16 in. dodge wheels work on the bumps??

binder56jd · Post by **binder56jd** » Mon Dec 10, 2007 5:21 pm

?? in subject??

fordman · Post by **fordman** » Mon Dec 10, 2007 5:30 pm

i dont know about 16 inch 8 lugs. i do know only the large pattern 15inch 5 on 5 1/ will fit our trucks. the small pattern 5 bolt wont fit our trucks but will fit ford cars.

binder56jd · Post by **binder56jd** » Mon Dec 10, 2007 5:51 pm

i should have been specific--sorry--thanks fman

yes

specifically 5 stud on 5 and 1/2 inch pattern

regards

FoMoCo · Post by **FoMoCo** » Fri Dec 14, 2007 7:16 am

All Dodge Ram 1500, Ram van 1500, 2005-up Dakota, and 2005-up Durango will fit 5x5.5. Sizes 15"s up to the 22"s fit

Nick

layedout72 · Post by **layedout72** » Sat Dec 15, 2007 2:34 pm

Why wouldn't any 5 5 1/2 work? Given the offset and all is correct? Is it the bearing caps or something?

fordman · Post by **fordman** » Sat Dec 15, 2007 6:56 pm

i would say that any wheel that is 5 on 5 1/2 would work as long as the center of the wheel is large enough to fit over the center hub of our trucks. dodge truck wheels will fit over the center hub of our trucks. i dont know if other will or if they are even made by any other company out there. stock wise that is.

layedout72 · Post by **layedout72** » Sun Dec 16, 2007 8:41 am

given theres enough material, could you not have them turned and open the hub "hole"? It wouldn't really cost that much, maybe 15 a wheel. That may open a few possibilities...

fordman · Post by **fordman** » Sun Dec 16, 2007 8:01 pm

good point. but i almost bet a person could find what he was looking for priced about the same as having them turned down. old steel wheels no one really wants them. they are great for scrap though. they are solid steel and get a better price than a whole car does.

lightning_msd · Post by **lightning_msd** » Sun Dec 16, 2007 8:11 pm

the new jeep grand cherekees have a 5 1/5 inch pattern. the ones that came with the hemis are pretty snazzy looking 18 inch i believe

Leadfoot · Post by **Leadfoot** » Tue Dec 18, 2007 1:17 am

are you talking about 3/4 and one tonne stuff?

because i know they work. but some have those goofy lugs like 80s fords with the flat washer instead of cone nuts.

The FORDification.com Forums

Which 16 in. dodge wheels work on the bumps??

Which 16 in. dodge wheels work on the bumps??

re: Which 16 in. dodge wheels work on the bumps??

re: Which 16 in. dodge wheels work on the bumps??

re: Which 16 in. dodge wheels work on the bumps??

re: Which 16 in. dodge wheels work on the bumps??