I beams

AustinTom · Post by **AustinTom** » Wed Oct 17, 2007 10:03 pm

Can F-250 I-beams and springs be bolted to a F-100 frame?

theskytoucher · Post by **theskytoucher** » Wed Oct 17, 2007 10:05 pm

Not 100% sure but I'm almost positive they will!!!

Post by **FORDification** » Wed Oct 17, 2007 10:34 pm

Yes, they'll fit...but I'm pretty sure the pivot bolts are a little larger in diameter, so you'd have to slightly widen the holes in the pivot bracket, just enough to use the larger bolts. It's been a while since I checked, so I could be wrong though. I do though that this is the case when using F250 rear springs on an F100. I'm using F250 springs in my F100 (with a couple leafs removed) and I had to widen out the holes in the frame brackets.

AustinTom · Post by **AustinTom** » Wed Oct 17, 2007 10:50 pm

Are you talkin about a little such as 1/8 or such as 1/64?

Post by **FORDification** » Wed Oct 17, 2007 10:54 pm

Like I said, I don't recall completely, but I'm thinking they were the next size up, which would've been 1/16" larger.

AustinTom · Post by **AustinTom** » Wed Oct 17, 2007 11:08 pm

Allright cool I'm fixin to swap in 3/4 ton suspension, and want to make sure that everything is gonna fit right beforehand.

The FORDification.com Forums

I beams

I beams

re: I beams

re: I beams

re: I beams