Can someone give the the specs on screw 52718-s (U-377-A)

[DuckRyder]

Shown in:

http://www.fordification.com/images/sch ... column.jpg

It holds the Gear shift indicator to the housing, I can't find them and its far enough together that I can't tell what it is supposed to look like.

TIA for any help.

[willowbilly3]

I can't find a way to blow the diagram up so I can read it but I have a couple junk columns and I could send you the screws if I had your address.

[DuckRyder]

PM Sent.

[willowbilly3]

Gotcha covered. In the mail tomorrow. I went down to send it this evening but they took out the stamp machine.

[DuckRyder]

Thanks willow!

Gotta love the post office, lots of them now have stamp machines that only take credit cards?

[4x4x4crewcab]

52718-S8 (U-377-A) would be the complete part number. It is listed as
SCREW-SELF TAPPING-PAN HEAD-CROSS RECESSED-POINTED with the Diameter of NO.6
Thread 18
Length 3/8

[4x4x4crewcab]

Diameter of NO.6

The front of this catalog goes on to explain size number 6
Maximum Decimal Diamete .138
Approximate Fractional Diameter 9/64
-----------------------------------------------
Hope this helps

[willowbilly3]

Mark, if you ever leave us you have to pass on the books and knowledge. You are amazing.

[DuckRyder]

Thanks Mark,

I think Willow send them to me, but if on the outside chance the truck is ready to drive before they arrive perhaps I can find something at the hardware store.

I'm hoping to at least fire the motor by Sunday, but waiting on several parts to finish.

[willowbilly3]

I got those off to you, a day or so late. I had to work a couple days there and it threw me off schedule. The lady at the P.O. pretty much made me buy a padded envelope so the are all safe and sound, tucked into their little puffy bed.
FWIW, where did you find a PRNDL that wasn't broke. I think all the ones I've owned were stuck back on with silicon at some point.

[DuckRyder]

Thanks willowbilly!

I got the PRND2L at Dennis Carpenter, it wasn't even that expensive.