glove box emblem fasteners

[Blue_Streak]

Making my truck into a Ranger and putting the reproduction Ranger emblem on the glove box door. Pins barely stick through. What fasteners are used to hold it on and where can I find them?

Same goes for the Ranger emblem on the side of the box. What fasteners are used there and where can I find them?

Thanks

[basketcase0302]

Did you try DC?
I'd also try these guys.

https://www.clipsandfasteners.com/Ford- ... s-s/63.htm

At one time years ago I had another source of Ford only fasteners but had a puter' crash when Hurricane Charlie took the power out and lost so...many vendor contacts.

[Blue_Streak]

Thank you.

I tried DC and could not find anything that would work to secure these emblems. I also tried your link and could not find anything there either.

[dave1972]

I bought a reproduction farm and ranch special emblem for the cowl and it was sent with two sided tape. What about getting some 3m double stick tape for your glove box emblem?

[basketcase0302]

That's what I thought the Ranger glove box emblem used to mount anyway, (double sided tape)?

[cstoyer]

They use a nut like the ones that the hood badges are held on with.

[Blue_Streak]

They use a nut like the ones that the hood badges are held on with.

Ok cool. I was thinking about the two sided tape as the pins barely protrude past the steel but the holes are fairly big so I got thinking maybe the nuts fit into the hole to help locate and tighten up against the first layer of steel.

Any idea where I might be able to get those for that small of a pin?

[chicof100]

Acorn nuts were used. take the emblem to hardware store, find acorn nut that fits, then install.