1967 GRILLE HARDWARE KIT..???

sick7f100 · Post by **sick7f100** » Fri Dec 27, 2013 12:18 pm

HI ALL, JUST RECENTLY PICKED UP MY 67 F100 FROM MY UNCLE, BUT IM HAVING A PROBLEM LOCATING A HARDWARE KIT FOR THE 67 GRILLE.. ANYBODY HAVE ANY ADVICE? I WOULD REALLY APPRECIATE IT. THANK YOU MUCH!

Calfdemon · Post by **Calfdemon** » Fri Dec 27, 2013 4:06 pm

What kind of "hardware" exactly are you looking for? The 67-69 grilles are not remanufactured at this time (68-69 are supposedly coming soon) as the original dies were lost in a fire years ago, so the only way to replace a 67-69 grille is to find a used one somewhere.

sick7f100 · Post by **sick7f100** » Fri Dec 27, 2013 9:31 pm

Thanks for the reply! I should have been a bit specific, as far as "hardware kit" I mean all the nuts, bolts, screws washers etc.. That are required to install it.I have a good Grille, that I just had polished. But the grille was not on the truck when I purchased it. So it's missing all that good stuff.

jimmy828 · Post by **jimmy828** » Fri Dec 27, 2013 11:02 pm

if i'm not mistaken the bolts are 5/16 x 18 with matching U-nuts where needed. IF you have a Lowes home improvement nearby,they will have what you need.

sick7f100 · Post by **sick7f100** » Sun Dec 29, 2013 8:05 pm

Went to a local Pick A Part, found a 68 and took some of the bolts out.. next went to king bolt and now have my kit ready! Thanks again!!

jimmy828 · Post by **jimmy828** » Sun Dec 29, 2013 8:22 pm

sick7f100 wrote:Went to a local Pick A Part, found a 68 and took some of the bolts out.. next went to king bolt and now have my kit ready! Thanks again!!

good going

The FORDification.com Forums

1967 GRILLE HARDWARE KIT..???

1967 GRILLE HARDWARE KIT..???

Re: 1967 GRILLE HARDWARE KIT..???

Re: 1967 GRILLE HARDWARE KIT..???

Re: 1967 GRILLE HARDWARE KIT..???

Re: 1967 GRILLE HARDWARE KIT..???

Re: 1967 GRILLE HARDWARE KIT..???