replacement floor pans

[Ashton_1012]

Hello everyone
I need floor pans for my 1972 f250, i have only found one site that sells them for about $42 a piece. The drivers side where the floor pan meets the wall of the cab, in front of the door, not sure what the call that haha, is also rusted out a little bit so I need to replace that section as well. Anyone know a good place to get some of these panels?

[TNIceWolf]

LMC....Dennis Carpenter...National Parts depot........and several others I am sure.

[jimmy828]

i am not much of a fabricator but when i installed new pans, i choose to use Dennis Carpenter products just so it would ease the installation. There was very little tweaking to do. Also NPD has the same replacement parts as DC. Looks like DC supplies parts to NPD.

[basketcase0302]

Try these guys.
http://www.rustrepair.com/floor_pan.htm

[undertakerman]

I have bought patch panels from LMC and NPD and have had to return them because of poor manufacturing. They had to be using old part stamp dies that were worn out. I highly recommend that you get your panels from Dennis Carpenter. They are OEM quality and fit with very little trimming. Square breaks not rounded breaks or extra metal that you would need to trim or a lighter gauge metal. You get what you pay for. My father used to say "the less you pay, the worse the problems and the more you pay the less problems you will have". With that said. Give your patch panels from Dennis Carpenter.