ok i dont know which way i want to go on Ibeams

69rangerf100 · Post by **69rangerf100** » Thu Aug 12, 2010 1:45 pm

ok i pulled a 73 front disk setup and the king pin size matches my 69 king pin set. the 73 beams are ready to be painted but i want to try and use the 69 beam my issue is i dont have any extra money right now to have them pressed out. if i go with the 73 beam i can get the truck to a rolling chassis faster. what do you guys think.

fordman · Post by **fordman** » Thu Aug 12, 2010 2:15 pm

heat and a hammer will get the pins out.

69rangerf100 · Post by **69rangerf100** » Thu Aug 12, 2010 2:18 pm

yeah my only problem is that it is no longer on the truck and i have taken the pivot bushing out so no way of putting them back on right now

fordman · Post by **fordman** » Thu Aug 12, 2010 2:19 pm

better to get at it with some heat.

69rangerf100 · Post by **69rangerf100** » Sat Aug 14, 2010 6:41 pm

success after several days of heating and hammering i finally got the king pins out of the i beams now to start sanding and get them painted

The FORDification.com Forums

ok i dont know which way i want to go on Ibeams

which beams to use

ok i dont know which way i want to go on Ibeams

Re: ok i dont know which way i want to go on Ibeams

Re: ok i dont know which way i want to go on Ibeams

Re: ok i dont know which way i want to go on Ibeams

Re: ok i dont know which way i want to go on Ibeams