99 merc disc brakes

[neverdone]

recently purchased a 99 merc mountaineer, i wanna swap the entire power brake system w/4 wheel discs, what parts will i need to do the entire swap from my donor merc??

thanks

[fordman]

i changed my answer. but does the 99 have i beams. probably but they are probably a ball joint type of setup. with a upper and lower ball type of deal. so will the ibeams from the 99 fit on the bump? if you can get away with it woulod the disc brake caliper holder bolt to you exsisting spindles. if it will. then you have to figure out if the disc will fit your spindles. and so on. there are going to be alot of differences to make that swap. look both of them over. make some measurements. then that will tell you if the swap is even possible. i think its more trouble than its worth. get a dentside and use those parts.

[neverdone]

well i wanna upgrade to the 03-up vicky swap, which would be close set up

but the merc is a strut set up =(...i'm going w/bags so i kinda want control arm set up..but either way i'll make it work

wonder if i can make the strut set up on my 67 f100??...any ideas...i'm trying to use as much parts as i can off this donor merc...low on money right now and i can always upgrade later..