67 f-100

[peanutman]

I'm looking at a 67 bump according to the vin it has a 352 engine. Don't know if it is orig engine. How can i look at engine and tell. Dip stick is on drivers side coming out block above pan. Water pump bottom hose is on same side.
It has a four speed, reverse is up and to the right. Knowing this much will the tranny bolt to my 302. If it is a 352 what other parts can i use It did not have a 4 speed orig. Hole was cut in floor to add. At on time it had a hurst type shifter probably had a 3 speed at one time.
This truck does have some good usable parts though- chrome grill, chrome front bumper, complete drive line,int parts and it's free i just have to go get it out of a vine thicket,. Need advise.

[F10YRB12118]

Dear peanutman,

I have a 67 F100 2WD LB w/ a 352.

I'm new and learning about Ford Bumpsides, I'm no expert, but it could be teh original engine.

The 352 that you describe is exactly like mine. From all info I have on my truck, it's 352 is original.

Here is a pic of my 352.

[F10YRB12118]

Pic of my 352, I hope?!

[SteveC]

dont forget that the 352 360 and 390 all look the same on the outside

[flatblack]

yes in order to find out you have to measure the stroke, i dont remember the measurements of each engine but im sure someone on here can help you out.

[basketcase0302]

Peanutman,

Keith's done all the work for us on ID'ing blocks in this tutorial:
http://www.fordification.com/engineID.htm

And here's your stroke measurements:

http://www.fordification.com/forum/view ... ure+stroke

Basketcase

[ford4x4fun]

If you do get it and decide to part it out, I have a couple things I would want off of it Basketcase gave the best advice thus far

[truckguy]

It has a T-18 in it.
Kyle

[peanutman]

Thanks for all the reply's. Will that tranny bolt up to my 302 bell housing. Thanks basket case for the link. Lools like i will have lots of parts available. But i need to know if i can make this tranny work on my 302.