smallest wire wheel?

worldsmysterie · Post by **worldsmysterie** » Wed Apr 02, 2008 4:35 pm

is there a good wire wheel that can get in the seem that goes down the side of the bed of the truck.

MadMaxetc · Post by **MadMaxetc** » Wed Apr 02, 2008 8:18 pm

I use the little one that goes in a Dremmel, if you don't have one just put it in your drill.

They are about 1" in diameter and about $3 each.

fordman · Post by **fordman** » Wed Apr 02, 2008 9:51 pm

you might find that a wire brush might not work for that. what you might have to use is a cut off wheel for a dremel. it is thin enough to get in there.

rjewkes · Post by **rjewkes** » Thu Apr 03, 2008 1:53 am

I have a die grinder with a cut off wheel. gently pressed into the seem it only seems to sand the metal and cut out the seam filler. does blow it every where though.

MaxKlinger · Post by **MaxKlinger** » Thu Apr 03, 2008 7:45 am

Be real careful when using cut off wheels. You could end up cutting things you don't want to cut.

Also, cut off wheels, especially the ultra-thin dremel ones, are very brittle and break easily.

rjewkes · Post by **rjewkes** » Thu Apr 03, 2008 10:41 am

The FORDification.com Forums

smallest wire wheel?

smallest wire wheel?

re: smallest wire wheel?