body plug

Tim P. · Post by **Tim P.** » Mon Oct 29, 2007 8:29 am

Is there a pug or metal plate for where the clutch rod goes thru the floor of cab if not using a clutch/manual tranny??

Tim P.

AustinTom · Post by **AustinTom** » Mon Oct 29, 2007 9:50 am

Yes there is I wish I still had a picture of it I'd show you

Tim P. · Post by **Tim P.** » Mon Oct 29, 2007 1:24 pm

AustinTom wrote:Yes there is I wish I still had a picture of it I'd show you

are they available somewhere?

Post by **FORDification** » Mon Oct 29, 2007 5:30 pm

It's just a flat piece of steel, slightly bent and with two holes to screw it down to the floorpan. Just fab something up yourself.

Tim P. · Post by **Tim P.** » Mon Oct 29, 2007 10:45 pm

it already has two holes the size of a 1/4 inch each side of the rodhole must be some big screws.

fordman · Post by **fordman** » Mon Oct 29, 2007 11:04 pm

i think they are big screws to start out with. i am taking a truck apart that has that rod through the floor now. ill get a pic of the screws and plate for you if it will help any.

Tim P. · Post by **Tim P.** » Mon Oct 29, 2007 11:05 pm

fordman wrote:i think they are big screws to start out with. i am taking a truck apart that has that rod through the floor now. ill get a pic of the screws and plate for you if it will help any.

if you have no use for the factory plate I would be intrested in this piece.

fordman · Post by **fordman** » Mon Oct 29, 2007 11:07 pm

its just a ringed type of plate with maybe a rubber boot on it. it wont seal for you. but if you want it i get it to you.

Tim P. · Post by **Tim P.** » Mon Oct 29, 2007 11:55 pm

the ring would be great I'll make a rubber gasket for sealing it to the floor pan.

fordman · Post by **fordman** » Tue Oct 30, 2007 12:01 am

ok
i ll get it tomorrow.

The FORDification.com Forums

body plug

body plug

body plug

re: body plug

re: body plug

re: body plug