steering column bearings

convincor · Post by **convincor** » Sat Oct 06, 2007 7:22 pm

Just a FYI. Rebuilt my 68 column today and both upper and lower bearings are the same as 65-66 mustang.
Here's the bearing- http://www.mustang-unl.com/itemdy01.asp ... y=EMUSTANG

And the sleeve- http://www.mustang-unl.com/itemdy00.asp ... &dep_key1=

flyboy2610 · Post by **flyboy2610** » Sat Oct 06, 2007 7:50 pm

Good to hear you got the column repaired!
Nice to know that about the bearings, too.

convincor · Post by **convincor** » Sat Oct 06, 2007 8:12 pm

Not completly done yet, but it'll all fit. I'm going take the column that's in the truck out as use the shaft from it as the lower part is in real good shape. Will just need to shorten that shaft for the P/S conversion.
I see the switch you put in this column is a Ford part. I was real happy to see that vs aftermarket.
Thanks again, Scott

The FORDification.com Forums

steering column bearings

steering column bearings

re: steering column bearings