King pin diameter?

wt4speed#2 · Post by **wt4speed#2** » Tue Mar 20, 2007 11:24 am

Does anyone one have the specs for the diameter of the king pins for our trucks ?
One of our members has shown interest in the reamer that I mentioned in an earlier thread and I was going to go by and at least check the price on it, but it would help if I new what range to look at.

thanks
Tony B

spartman · Post by **spartman** » Tue Mar 20, 2007 11:56 am

Check here:

http://www.fordification.com/Ibeams&spindles.htm

wt4speed#2 · Post by **wt4speed#2** » Tue Mar 20, 2007 11:59 am

I looked there but I couldn't see where it gave the actual diameter

Tony B

spartman · Post by **spartman** » Tue Mar 20, 2007 12:03 pm

I take it the values you are looking for aren't in the left hand column?

Not trying to be a smart arse here.

King Pin dia. (in.)

.8592" x 6.353"
.8593" x 6.483"
1.0540" x 6.450"

wt4speed#2 · Post by **wt4speed#2** » Tue Mar 20, 2007 12:09 pm

My footnotes say pay no attention to the values in the blue shaded area

Thanks spartsman, I guess i was looking too hard,often the obvious is overlooked

Tony B

spartman · Post by **spartman** » Tue Mar 20, 2007 12:10 pm

No problem.

Have been accused of doing it myself.

Not that I would ever admit to it......