Is this correct for our mode?

[rjewkes]

or is this a cheby rear slider Or worse a 73-79?
http://cgi.ebay.com/ebaymotors/ws/eBayI ... otohosting

[mrsnicks]

Looks to be the factory slider from what I can tell. They had aluminum looking frames, and the 73-up windows where wider than that.

If you get get a picture of the closing mechanism on the other side I'd be able to tell for sure.

Patrick

[rjewkes]

as long as it will fit our windows i didn't think they shaped like that.

It is an ebay auction .99 plus 20 for shipping.

[mk]

Somebody's gonna get a heck of a deal. They weren't offered in our trucks until about 70, as far as I know. At least I've never seen an original with a date coded glass older than that.


mike

[tynall44]

that is a 73 and up window look at the bottom corners

[fordman]

it looks to tall to me and not wide enough. i can't tell anything by looking at the corners. what am i looking for?

[rjewkes]

the bottom corners look to be triangular and not round.

If it is 73-79 then i can probably resell it to a friend for 30.00 and make 10.00 off the deal.


OOps as i typed this one i was outbid on ebay it went for 26.50. My highest was 25. Oh well wait till the winner discovers it is from a 73-79.

[FORDification]

No, it was a bumpside unit. Compare it with the one in this shot:

[flyboy2610]

Yup. That is what the slider on my '69 looks like.

[foghorn]

Well keith beat me to it but i was gonna say after market bump window. I used to install these all the time back in the 70's

foggy

[rjewkes]

dang just a dfollar or two more i hope the winning bidder backs out. id gladly pay 26.50 plus the 20 shipping.